Ozone Compatible Venturi Injectors

Short Description:

OZONE VENTURI INJECTOR Dino Purification’s venturi injectors are differential pressure injectors with internal mixing vanes. Superiority of Dino injectors is due to the unique, patented design which maximizes injector efficiency, suction capacity and mixing capabilities. The operating costs of Dino injectors are lower than less efficient systems, and Dino injectors are trouble-free because they have no moving parts. How a Venturi Injector Works When pressurized water enters the injector inlet...


Product Detail

Product Tags

OZONE VENTURI INJECTOR

Dino Purification’s venturi injectors are differential pressure injectors with internal mixing vanes. Superiority of Dino injectors is due to the unique, patented design which maximizes injector efficiency, suction capacity and mixing capabilities. The operating costs of Dino injectors are lower than less efficient systems, and Dino injectors are trouble-free because they have no moving parts.

How a Venturi Injector Works

When pressurized water enters the injector inlet, it is constricted toward the injection chamber and changes into a high-velocity jet stream. The increase in velocity through the injection chamber results in a decrease in absolute pressure, creating a vacuum, thereby enabling an additive material to be drawn through the suction port and entrained into the water stream. As the jet stream is diffused toward the injector outlet, its velocity is reduced and it is reconverted into lower pressure energy.

Performance

Dino Purification venturi injectors operate over a wide range of pressures and require only a minimal pressure differential between the inlet and outlet sides to initiate a vacuum at the suction port. The injectors’ internal mixing vanes create thousands of micro bubbles which greatly increases the surface area of gas (oxygen, ozone, etc.) in contact with the liquid (several micro bubbles have a greater surface area than one large bubble of the same volume).

Product technic data:

Model

Flow rate

Fluid connection

Gas port connection

Material

Max pressure

Max

Temperature

Length (mm)

A12057

0.83-3.33 LPM

1/4” MNPT

1/8” Barb

PVDF

200 PSI

(14.06 Bar)

200°F

(93.33°C)

57

A25100

3.33-16.6 LPM

1/2“ MNPT

1/4” Barb

100

A25152

16.6-50 LPM

3/4“ MNPT

1/4” Bard

152

A32235

50-166 LPM

1“ MNPT

1/2” Barb

230

A48275

166-416 LPM

1.5“ MNPT

1/2” Barb

275

A58295

416-833 LPM

2“ MNPT

1/2” Barb

295


Why Dino?

Over 12 years of manufacturing and marketing experience

High quality with low cost compared to others mixing device

Safe to use as the chemicals are injected under vacuum, not pressure

Injectors are available in stainless steel, Polypropylene (PP), Polyvinylidene Fluoride (PVDF)


  • Previous:
  • Next: